FN issues Optic Optical Lebetel Bulletin for FN Guns Rdless MRD

(Mclean, via 2025) fn man America discover, or interference of the premium has been limited with a rfx11 wedding the furniture has been marked “604” that were too long. In this case, the screws marked “603” they must be used.

When mounting each optics to the mrd reflection, it is imperative to use the correct screw and only the correct screw screwed. Don’t use the screws provided by the optic manufacturer because those screws were not conceived for interface specifically with mrd reflection and could cause damage to slide.

The chart in the owner’s owner’s manual owner that fails the size. Has been updated to include rfx11 widely. When you stalling the RFX11 IIIDID before installing all other optics, refer to the graph in the owner’s manual for the correct size screws. If your optic is not listed, contact FN Customer Service to 1-800-635-1321, or by Customer.com Customer.

Figure 1

Vice 603 on top. 604 on the bottom.

To ensure that the provided screws provided: As they hold the optics separately from the gun, put the screws through the optics or counting the wires; There should not be more than .045 inches, or 3 visible wires (Figure 2). The screws should also be installed to the correct torque (6 – 8 in / lbs), indipuliously of what can be recommended by the octic manufacturer. Learn to have not exceeded beyond the correct torque settings like this may deform or compress the optic accommodation.

Figure 2

Not more than 3 wires or .045 inches below the surface of the dot dot on miniature (mdd).

To see and read the fn reflections of the Owner’s owner of Reflex or Optic, please visit fnamerica.com/customer-support/owners-manualal. I am

For questions about this bulletin or assistance of service in the fn repair or evaluation, the fn customer service to 1-800-63212121, or by email in customers. Operation hours are 8 hours at 17 hours of the Eastern Time, Monday to Friday.